FateSlayer+: Kickstarter läuft

Bei Kickstarter suchen wieder einige Modelle nach Fans.

Welcome to the Fateslayer+ kickstarter campaign! Everything here will be very forward and direct, no renders, no pretenses, just 75mm scale resin figures. These figures are all designed and printed by me and will also be molded and casted in-house. The rewards will be located below and will outline each tiered reward.

Funding for this kickstarter goes towards a webshop, equipment, and overall bringing the world of Fateslayer to life.

Und das sind die Modelle:

Click on each respective characters for a turn-around.

Einen Größenvergleich gibt es auch:

Das sind die Preise:

This has been a one man job for a couple of years. From conceptual design, molding and casting to graphic design; I pride myself in my ability to be knowledgeable in every process. Though I am a one man team, rest assured, I am able to scale correctly in manufacturing all the models and have molders/casters on back up in the event the kickstarter reaches higher goals.

There are no 3d renders on this kickstarter, the models you see here are initial prototypes printed on a 3d printer then tooled. The final models will most likely be printed on a superior 3d printer to have crisper details than the current shown models. Once everything is cleaned, the pieces will then be ready to be molded and casted. After everything is casted, they are cleaned once more to remove any residue and then finally are ready to be packaged and sent to their final destination.

Each piece has been cut up and fitted, every piece that is photographed is put together without adhesives, but is recommended for stronger bonding.

Stretch Goals sind auch geplant:

Die Kampagne läuft noch 24 Tage.

Quelle: FateSlayer+